1、有足夠的剛度和強度承受構件在自重、風荷載和地震荷載作用下傳遞給預埋件的內力。
1. It has sufficient stiffness and strength to bear the internal force transmitted to the embedded parts by the member under the action of self weight, wind load and seismic load.
2、滿足運輸、安裝吊運過程中的施工荷載的要求。
2. Meet the requirements of construction load during transportation, installation and hoisting.
3、對于變形受到限制將產生較大內力的構件，其埋件應與連接件共同組成可位移彈性接點體系。
3. For members whose deformation is limited and will produce large internal force, their embedded parts and connectors shall form a displaceable elastic contact system.
4、預埋件在GRC內錨固牢固，錨固筋與鍍鋅埋件的連接不會破壞鍍鋅層。錨固筋的錨固長度符合鋼筋在混凝土中錨固長度的要求，并有足夠厚度的保護層。
4. Embedded parts shall be firmly anchored in GRC, and the connection between anchor bar and galvanized embedded parts will not damage the galvanized layer. The anchorage length of the anchor reinforcement shall meet the requirements of the anchorage length of the reinforcement in the concrete, and there shall be a protective layer of sufficient thickness.
5、預埋件及錨固筋處構件應局部加強以適應應力集中的作用。
5. The components at embedded parts and anchor bars shall be locally strengthened to adapt to the effect of stress concentration.
6、預埋件位置正確。特別是處于邊緣部位的構件如
6. The position of embedded parts is correct. Especially components at the edge, such as
Shandong GRC component provides you with the above wonderful contents. For more wonderful contents, please click to enter our website: http://www.xinyanse.com We will have more content for you to check later.
